AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 240

Proaramming Procedures
Block Assignment
Use this procedure to assign each DID trunk connected to the system either to
Block 1 or Block 2.
NOTE:
DID trunks apply only in Hybrid/PBX mode.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Block Assignment
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Sys Program
Exit
[F1]
press any key
System manager
Hybrid/PBX
Not required
Form 3d, Incoming Trunks - DID
Block 1
Block 1, Block 2
Yes
Yes
LinesTrunks DID
Enter Select trunk lines
Enter Toggle LED On/Off"
Exit E x i t
[F4] [F4] [F1]
[F10]
Select trunk lines
[F10] [F5] [F5]
[F5]
Block Dial trunk block no.
Type trunk block no.
Enter
Type trunk block no.
Toggle letter G On/Off
[F5]
Block Assignment
Exit
3-149