AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 298

Programming Procedures
Terminal Equipment Identifier
Use this procedure to assign the link layer address of a piece of equipment
connected to each D-channel. Normally, only one piece is connected and the
system assumes that the Terminal Equipment Identifier (TEI) is 0.
CAUTION:
The value of the TEI rarely has to be changed.
Check with your authorized support representative before changing
this value.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Terminal Equipment Identifier
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Sys Program
Exit
[F1]
press any key
System manager
All
Not required
Form 3b, Incoming Trunks - DS1 Connectivity (100D
Module)
0
0 - 6 3
No
No
LinesTrunks PRI
no. Enter Drop
Exit Exit E x i t
[F4] [F6] [F6]
[F10] [Alt] [P]
+
[F5] [F5] [ F 5 ]
Terminal Equipment Identifier
[F5]
Protocol TEI Dial sIot
Dial new ID no. Enter
[F2]
Type slot no.
[F10]
Type new ID no.
3-207