AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 600

Programming Procedures
Pool Routing
Use this procedure to identify the trunk pools on which to route calls to area
codes and/or exchanges included in ARS tables.
A maximum of 6 routes (numbered 1 through 6) can be specified for each
subpattern. Pool routing is programmed for Tables 1 through 16. Table 17 is
the Default Toll table and Table 18 is the Default Local table.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press
Summary: Pool Routing
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Sys Program
press any key
on the PC before saving your entry or menu selection.
System manager
Hybrid/PBX
Not required
Form 9b, Automatic Route Selection Tables
Form 9c, Automatic Route Selection Default and Special
Numbers Tables
Not applicable
Not applicable
No
No
Tables
table no. and pool route no.
out code
[F8] [F6]
pool route no.
[F10]
Exit
[F1] [F5]
ARS Sub A Pools/Sub B Pool
Enter
Enter Exit
[F3]/3[F10]
[F10]
Type pool dial-out code
[F5] [F5]
Dial
Dial pool dial-
Exit
Type table no. and
Pool Routing 3-509