AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 242

Programming Procedures
Display/Instructions
Step
For a single line, go to Step 7a.
For a block of lines, go to
Step 7b.
x = block entered in Step 4
For a single line, do the
following:
1. Select Entry Mode.
2. Specify the line or trunk.
3. To delete the trunk from
the block
To save your entry and
specify trunk(s) for the
other trunk block
If next trunk number
is sequential
Your previous entry
saved and the next trunk
number is shown on line
1.
If next trunk number
is not sequential
On the console
Select Entry Mode.
Dial [nnn].
Select Delete.
Select Next.
Repeat number 2 in
Step 7a.
IS
Select Exit.
Repeat Steps 3-7a.
On the PC
[F6]
Press
Type [nnn].
[F8]
Press
[F9]
Press
Repeat number 2 in
Step 7a.
[F5]
Press
Repeat Steps 3-7a.
Block Assignment 3-151