AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 471

Programming Procedures
Group Calling Trunk or Pool Assignments
Use this procedure to assignor remove trunks or pools (Hybrid/PBX only) that
ring directly into a calling group.
Incoming calls on each trunk or pool can be directed to only one calling group.
To reassign a trunk or pool to a new calling group, you must remove it from its
old group before making the new assignment.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press
Summary: Group Calling Trunk or Pool Assignments
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
3-380 Group Calling Trunk or Pool Assignments
Sys Program
press any key
on the PC before saving your entry or menu selection.
System manager
All
Not required
Form 6e, Group Calling
Not applicable
Line/trunk number
Yes
No
Extensions
Dial calling group ext. no.
Enter
[F6] [PgUp]
ext. no.
[F5] [F5]
Exit
[F1] [F5]
More Grp Calling
Enter
Exit Exit E x i t
[F4] [F10]
[F10]
Type trunk no.
Line/Pool
Dial trunk no.
Type calling group
[F10] [F5]