AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 338

Programming Procedures
Trunks are assigned to buttons in the order that you press each trunk button on
the system programming console or keyboard. Existing trunk assignments can
be rearranged by removing all current assignments and then pressing the trunk
buttons on the console or keyboard in the order that they should appear on the
buttons. For information on the order of the programmed buttons, refer to the
button numbers on the applicable planning form for each telephone.
If you want to reserve some blank buttons for features between trunk buttons, a
line must be assigned as a placeholder for each blank button. After all trunks
are assigned, remove the trunks used as placeholders on the buttons reserved
for features.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press
Summary Assign Trunks or Pools to Telephones
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Sys Program
press any key
on the PC before saving your entry or menu selection.
System manager
All, but note differences in factory settings
Telephone idle
Form 4b, Analog Multiline Telephone
Form 4d, MLX Telephone
Form 4e, MFM Adjunct — MLX Telephone
Form 4f, Tip/Ring Equipment
Form 5a, Direct-Line Console (DLC) - Analog
Form 5b, Direct-Line Console (DLC) - Digital
Form 5c, MFM Adjunct — DLC
Data Form 2a, Analog Data Station
Data Form 2b, Digital Data Station
Key Mode: Intercom Ring button, Intercom Voice
button, and the first eight lines connected to the control
unit are assigned to all analog multiline telephones,
MLX telephones (excluding operator positions), and
MFMs connected to MLX telephones. Two Intercom
Ring buttons are assigned to single-line telephones; no
outside lines are assigned.
Assign Trunks or Pools to Telephones
Exit
[F1] [F5]
3-247