AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 200

Programming Procedures
Zero Code Suppression
Use this procedure to specify zero code suppression for the 100D module as
AMI Zero Code Suppression (AMI-ZCS) or Bipolar 8 Zero Suppression (B8ZS).
Your selection must match the suppression at the far end of the DS1 facility.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Zero Code Suppression
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Sys Program Exit
[F1]
press any key
System manager
All
100D module idle
Form 3b, Incoming Trunks - DS1 Connectivity (100D
Module)
AMI-ZCS
AMI-ZCS, B8ZS
No
No
Lines Trunks LS/GS/DS1
Suppression Select zero code suppression
Enter Exit Exit
[F1]
[F4] Type slot no.
Select zero code suppression
[F5]
Dial SIot no.
[F10]
[F10] [F5]
Zero Code Suppression
Enter
[F3]
[F5]
3-109