AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 61

Programming with SPM
With a Direct Local Connection
To
access SPM when your PC is connected directly to the control unit, follow
these steps:
Display
Step
If you do not have a hard disk, insert the SPM diskette into Drive A and
switch to Drive A, if it is not already the current drive.
Start the SPM program by typing spin. The SPM Welcome screen appears
as shown in Step 3.
With a Local or Remote Modem Connection
The method you use to access SPM by modem depends on whether you are
programming on-site or from a remote location.
If you are on-site, the modem must be connected to an 012 module on the
control unit. To establish a connection to the control unit's internal modem, dial
* 1 0 .
If you are at a remote location, do one of the following:
Place a call to the system on a Remote Access line, enter the barrier
code (if required), and dial the code for the internal modem (*10).
Place a voice call to the system on a regular line and ask the operator to
transfer you to the modem (by dialing *10), When you hear answer
tone, switch to data mode.
You can also set up the remote connection in the other direction. Place a voice
call from the system to the remote PC running SPM and then transfer the call to
the modem.
Instructions
Press any key. The SPM Main Menu
appears as shown in Step 4.
If the Main Menu does not appear or if the
information on the screen is garbled, press
any key again.
Select an option by pressing one of the
function keys.
Starting SPM
2-11