AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 139

Programming Procedures
DLC Operator Positions
DLC operator positions can be assigned to the first and fifth ports on the first
modules with digital or analog multiline station jacks. A maximum of eight DLC
operator positions can be assigned. Any combination of operator positions can
be assigned as long as there are no more than four QCC operators and no
more than 8 operators in total.
Use this procedure to specify telephones that serve as central answering
positions for all incoming calls, for Call Management Systems connected to
operator ports, or as calling group supervisors. (You do not need to use this
procedure in a Key or Behind Switch system unless you have more than one
DLC position. ) Trunks are assigned on individual buttons. The system
programming console can have several incoming calls ringing simultaneously.
For a new system, remove the factory set DLC operator position assignment for
any telephone not used as an operator position.
Each CMS requires two DLC operator positions to connect the equipment and
one position to serve as CMS supervisor.
Entering Programming
Console: Select Menu
PC/SPM: Type
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[ F5 ]
press on the PC before saving your entry or menu selection.
Summary: Identify or Remove DLC Operator Positions
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
DLC Operator Positions
3-48
Sys Program
[ F1 ]
press any key
SPM
System manager
All
System idle
Form 2a, System Numbering - Station Jacks
Type - DLC
First or fifth ports (maximum — 2 per module,
maximum — 8 DLCs per system)
Yes
No
Operator Positions
no. Enter
[ F3 ] [ F1 ] [ F1 ]
Exit
[ F5 ]
Direct Line
StoreAll
Type ext. no. [ F10 ]
Dial ext.
[ F3 ]