AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 124

Programming Procedures
Block Renumbering
Use this procedure to assign extension numbers to a group of extensions,
accessories, or lines. Both the original numbers and the numbers they are
being changed to must be sequentially numbered.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
CAUTION:
Select Exit on the console,
renumbering extensions. If you press Home, extensions may remain in
the forced idle condition (indicated when the LED next to each DSS
button is on). To restore extensions to their normal operating state,
restart the system.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[ F5 ]
press
Summary: Block Renumbering
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
[ F5 ]
Sys Program
press any key
on the PC before saving your entry or menu selection.
System manager
All
System idle
Form 2a, System Numbering – Station Jacks
Form 2b, System Numbering – Digital Adjuncts
Form 2d, System Numbering – Special Renumbers
Not applicable
Old and new extension numbers
Yes
No
on the PC, when you have
Exit
[ F1 ] [ F5 ]
Block Renumbering
3-33