AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 605

Programming Procedures
Facility Restriction Level
Use this procedure to assign a Facility Restriction Level (FRL) to each route.
The FRL ranges from 0 (least restrictive) through 6 (most restrictive) and is used
to restrict user access to the route. The FRL assigned to telephones and
Remote Access users is opposite from the FRL assigned to routes, where 0 is
the most and 6 is the least restrictive.
NOTE:
Pool routes must be programmed before you assign Facility Restriction
Levels.
Facility Restriction Levels are assigned to Tables 1 through 18. Table 17 is the
default toll table and Table 18 is the default local table.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Facility Restriction Level
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
3-514 Facility Restriction Level
Sys Program
Exit
[F1]
press any key
System manager
Hybrid/PBX
Not required
Form 9b, Automatic Route Selection Tables
Form 9c, Automatic Route Selection Default and Special
Numbers Tables
3
0 - 6
No
No
Tables ARS Sub A FRL / More and Sub B FRL
Dial table no. and pool route no.
restriction level Enter
[F8] [F6] [F4]/[PgUp]
no. and pool route no.
[F10] [F5] [F5]
[F5]
Enter Dial
Exit Exit
[F1]
and Type table
[F10]
Type restriction level