AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 176

Programming Procedures
Display/Instructions
Step
2. Specify the trunks
assigned to ring into the
QCC queue.
Trunk number
Slot and port number
Logical ID number
3. To remove trunks from
the specified QCC
operator
4. To assign trunks to the
specified QCC operator
and assign trunks to
another QCC operator
If next QCC
operator is
sequential
Your previous entry is
saved, and next QCC
operator is shown on
line 1.
If next QCC
operator is not
sequential
5. To assign telephone as
principal user trunks to
QCC operator when all
entries are complete
On the console
Dial [nnn].
Dial # [sspp]
Dial # [nnn].
Select Delete.
Select Next.
Repeat number 2 in
Step 7a.
Select Enter.
Repeat Steps 3-7a
Select Enter.
QCC Operator to Receive Calls
On the PC
Type [mm].
Type # [sspp].
Type # [nnn].
[F8]
Press
[F9]
Press
Repeat number 2 in
Step 7a.
[F10]
Press
Repeat Steps 3-7a.
[F10]
Press
3-85