AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 129

Programming Procedures
Direct Station Selector (DSS) Page Buttons
Use this procedure to set the three Page buttons on the DSS to correspond to
the system numbering plan. This procedure assigns extension numbers to DSS
buttons. You cannot program individual buttons on a DSS; this is the only
method for programming DSS buttons.
If only one DSS is attached, each Page button assignment sets the console for
a range of 50 extension numbers. If two DSSs are attached, each Page button
assignment sets the console for a range of 100 extension numbers. Page
button assignment should be sequential (Page 1: 0-49, Page 2: 50-99,
Page 3: 100- 149).
NOTE:
If two DSSs are attached, change the factory setting so that the difference
between extension numbers assigned to the range is at least 100. For
example, assign Page 1 to begin with extension 10, Page 2 to begin with
extension 110, and Page 3 to begin with extension 210.
Operator Park Zone codes must be included in the extension number range
specified for one of the Page buttons.
C A U T I O N :
Select Exit on the console,
this procedure. If you press Home, extensions may remain in the
forced idle condition (the LED next to each DSS button is on), and the
system may have to be restarted.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[ F5 ]
press
3-38 Direct Station Selector (DSS) Page Buttons
[ F5 ]
Sys Program
press any key
on the PC before saving your entry or menu selection,
on the PC, when you have finished
Exit
[ F1 ] [ F5 ]