AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 479

Programming Procedures
Group Calling Delay Announcement
Use this procedure to designate the announcement device used to play
messages to callers while they are waiting in the queue.
Only one announcement device can be designated for each calling group;
however, more than one calling group can use the same announcement device.
The delay announcement device should not be programmed as a calling group
member.
If the station jack or MFM was previously programmed as a regular station, you
must remove all trunk button assignments before you designate the station jack
as a delay announcement device.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Group Calling DeIay Announcement
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
3-388 Group Calling Delay Announcement
Sys Program
Exit
[F1]
press any key
System manager
All
Not required
Form 6e, Group Calling
No delay announcement devices are assigned.
Announcement, No announcement
No
No
Extensions More
DelayAnnce Dial Calling group ext. no.
Dial ext. no. of announcement device
E x i t
[F6] [PgUp] [F4]
[F10]
ext. no. Type ext. no. of announcement
[F10] [F5]
device
[F5]
Grp Calling
Enter
[F2]
Type calling group
[F5]
Enter
Exit