AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 357

Programming Procedures
The following table provides the programming codes for assigning Ring and
Voice buttons. You can handle errors in data entry as follows:
If you enter a feature code incorrectly while programming, the message
programming Error displays and the red LED next to the button
flashes. If this happens, press the button again and repeat the
procedure.
If you make a mistake and program the wrong feature on a button, press
the button, select Delete (or
again,
Table 3-4. Programming Codes for Assigning SA/ICOM Ring and Voice Buttons
Instruction
To assign System Access or Intercom
Ring button
To assign System Access or Intercom
Voice button
To assign System Access or Intercom
Originate Only-Ring button
To assign System Access or Intercom
Originate Only—Voice button
To assign System Access Shared
button
To change current assignment for
System Access or Intercom Voice,
Originate Only or System Access
Shared buttons from Voice to Ring
3-266 Assign Intercom or System Access Buttons
[F2]
on the PC) and press the button
On the Console
Dial 16
Dial 16, press button being
programmed again, and Dial
19
Dial 18
Dial 18, press button being
programmed again, and dial
19
Dial 17, press the extension
number of principal
telephone: [nnnn] then press
the + button number of
specific button being shared:
[nn]
Dial 19
On the PC
Type 16
Type 16, press Shift +
function key for button being
programmed again, and Type
19
Type 18
Type 18, press shift +
function key for button being
programmed again, and type
19
Type 17, press the extension
number of principal telephone
[nnnn] then press the+ button
number of specific button
being shared: [nn]
Type 19