AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 79

Programming with SPM
Print Options
The Print Opts option allows qualified service personnel to direct system
programming reports either to the PC (where you can save them, browse
through them, or print them with the System Programming Print procedure) or to
the SMDR printer. The Print procedure is described in detail in Chapter 2. This
option merely specifies where reports are to be sent.
Step
Restore
The Restore option allows qualified service personnel to load system
programming from a diskette or from the hard disk into the processor module
memory. (You must have backed up system programming to use this
procedure.)
This procedure is used to program a new system if a disk was created through
surrogate mode programming or to restore information lost through system
failure. It is also part of the upgrading procedure.
The system must be idle during a Restore procedure.
Display Instructions
Select Print Opts by pressing
Specify the target device for reports:
Press
m e n u .
—
[ F1 ]
Press for the SMDR printer.
[ F2 ]
Press for the PC.
[ F5 ]
(Exit) to return to the main
Using SPM
[ F4 ].
2-29