AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 342

Programming Procedures
Display/Instructions
Step
If next extension
number is not
sequential
To save your entry when all
entries are complete
For a block of lines, do the
following:
1. Select the trunks
associated with the 20
line buttons on the
system programming
console.
2. Assign trunk or pool to
telephone.
The green LED indicates the
following:
on = trunk or pool assigned
to telephone
off = trunk or pool not assigned
to telephone
For Hybrid/PBX only: The red
LED indicates the following:
on = trunk assigned to pool
off = trunk not assigned to
pool
3. Save your entry.
To return to System
Programming menu
On the console
Select Enter.
Repeat Steps 4-6a.
Select Enter.
Select Lines 01-20,
Lines 21-40, Lines
41-60, or Lines 61-
80.
Toggle the LED On/Off,
as required.
Select Enter.
Select Exit two times.
Assign Trunks or Pools to Telephones
On the PC
[F10]
Press
Repeat Steps 4-6a.
[F10]
Press
[F1], [F2],
Press
[F3], [F4]
or
Toggle the letter G (or
R) On/Off, as required.
[F10]
Press
[F5]
Press two times.
3-251