AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 147

Programming Procedures
Outmode Signaling for Loop or Ground Start
Trunks
Use this procedure to identify either touch-tone signaling or rotary dial signaling
for outgoing calls placed by using each loop-or ground-start trunk.
NOTE:
This procedure is not required if your system has only touch-tone
lines/trunks.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection,
Summary: Outmode Signaling for Loop or Ground Trunks
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
Entry mode available
†
3-56 Outmode Signaling for Loop or Ground Start Trunks
Sys Program
[F1]
press any key
System manager
Loop Start - All; Ground Start - Hybrid/PBX only
Not required
Form 2c, System Numbering – Trunk Jacks
Touch-tone
Touch-tone, rotary
N o
Yes
t To program a single extension:
LinesTrunks TT/LS Disc
entry mode Dial no. of the line
Exit Exit
To program a block of extensions:
Lines Trunks TT/LS Disc
block of lines Toggle LED On/Off
Exit Exit
Exit
[F5]
Outmode
Enter
OutMode
Enter
Select
Exit
Select
Exit