AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 171

Programming Procedures
Display/Instructions
Step
4. To assign trunks to the
specified priority level
and assign trunks to
another priority level
If next priority level
is sequential
Your previous entry is
saved, and next priority
level is
shown on line 1 in the
screen in Step 7.
If next priority level
is
not sequential
5. To assign priority level
for trunk when all entries
are complete
For a block of lines, do the
7 b
following:
1.
Select the trunks
associated with the 20
line buttons on the
system programming
console.
2. Assign queue priority
specified.
The green LED indicates the
following:
on = to assign the queue
priority specified
off = not to assign priority
Save your entry.
3.
To return to System
Programming menu
3-80 QCC Operator to Receive Calls
On the console
Select Next.
Repeat Step 7a.
Select Enter.
Repeat Steps 3-7a.
Select Enter.
Select Lines 01-20,
Lines 21–40,
Lines 41–60,
or Lines 61-80.
Toggle the LED On/Off,
as required.
Select Enter.
Select Exit two times.
On the PC
[F9]
Press
Repeat Step 7a.
[F10]
Press
Repeat Steps 3-7a.
[F10]
Press
[F1], [F2],
Press
[F3], [F4]
or
Toggle the letter G
On/Off, as required.
[F10]
Press
[F5]
Press two times.