AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 491

Programming Procedures
Group Calling Message Waiting Indicator
Use this procedure to designate a telephone to receive calling group message-
waiting indications (MWI).
Only one telephone can be designated as a message-waiting receiver for each
calling group; however, more than one calling group can use the same
message-waiting receiver. The telephone assigned as a message-waiting
receiver does not have to be a member of the calling group.
Message-waiting indications cannot be sent to the extension assigned to the
group unless this option is programmed. The message-waiting receiver cannot
distinguish between messages left for the calling group and personal
messages.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Group Calling Message Waiting Indicator
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
3-400 Group Calling Message Waiting Indicator
Sys Program
Exit
[F1]
press any key
System manager
All
Not required
Form 6e, Group Calling
No message-waiting receiver assigned
Extension number
No
No
Extensions More
Dial calling group ext. no.
MWI receiver Enter
[F6] [PgUp] [F4]
[F10]
ext. no. Type ext. no. for MWI receiver
[F10] [F5] [F5]
[F5]
Grp Calling Message
Enter Dial ext. no. for
Exit Exit
[F4]
Type calling group