AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 301

Programming Procedures
Dial Plan Routing
Dial Plan Routing is available only in Hybrid/PBX mode. Key and Behind Switch
systems route incoming calls by line.
Dial Plan Routing provides a way of routing incoming calls on a "per B-channel
group" basis. An incoming call is routed by matching the incoming number (by
service, number of digits, and pattern) and then optionally deleting and/or
adding digits to direct the call to a specific endpoint. A service must be
specified; the number of digits and pattern are optional. For example, you can
specify that calls received from a particular area code should be routed to the
specific individual or group responsible for accounts in that area.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Dial Plan Routing
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
3-210 Dial Plan Routing
Sys Program
Exit
[F1]
press any key
System manager
Hybrid/PBX
Not required
System Form 3b, Incoming Trunks - DS1 Connectivity
(100D Module)
Not applicable
Not applicable
No
No
[F5]