AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 85

Proaramming with SPM
6. Insert the SPM diskette into the floppy disk drive and press
A request for confirmation appears.
7. Press
You are prompted to insert the SPM diskette.
8. Press
The system shows the progress of the installation by displaying dots at
the rate of one dot per second. The procedure takes about 3½ minutes.
When the installation is finished, a confirmation message appears.
9. Press
You are prompted to remove the SPM diskette and to shut down the
system.
10. Remove the diskette and press
(If you press
software is not installed until you shut down and reboot. )
When shutdown is finished, you are prompted to reboot the system.
11. Press the PC's reset button or
The installation procedure is complete. Since the UNIX system version of SPM
does not have to be initialized, you are ready to use SPM.
Initializing the SPM Software
To run correctly, the DOS version of SPM requires certain information
(transmission speed, type of monitor, etc.). This information needs to be
supplied only once, the first time you run SPM.
The information provided during the initialization process is written to the SPM
configuration file (ares.cfg). If you need to change this information at some
later time, you can do so in either of the following ways:
Invoke SPM with one or more of the following options, for example,
Any of these options changes the information in ams.cfg.
spm -com1
spm -com2
spm -s1200
spm -s2400
spm -color
spm -mono
[ ]
to continue.
[ ]
to continue.
[ ]
to continue.
—
[ Esc ]
instead, you can continue running SPM; however, the
[ Alt ] + [ Ctrl ] + [ Delete ]
spm -com1 -s1200 -color -1 french
specifies COM1 as the communications port
used by SPM.
specifies COM2 as the communications port
used by SPM.
specifies modem speed of 1200 bps.
specifies modem speed of 2400 bps.
specifies color monitor.
specifies monochrome monitor.
[ ]
to shut down the system.
Installing the SPM Software
[ ].
to reboot.
2-35