AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 285

Programming Procedures
Telephone Number to Send
Use this procedure to assign the telephone number to send to the network when
outgoing calls are made on an ISDN line. If the person being called subscribes
to an automatic number identification service, the number indicates who is
calling.
The number assigned to each channel does not have to be unique because it is
not used for routing.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary Telephone Number to Send
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Telephone Number to Send
3-194
Sys Program
Exit
[F1]
press any key
System manager
All
Not required
Form 3b, Incoming Trunks - DS1 Connectivity (100D
Module)
No digits are assigned
Up to 12 digits in any combination of the digits 0-9
No
No
LinesTrunks PRI
type of no. Enter
Dial line no. Enter
Enter Exit Exit
[F4] [F6] [F3]
[F10] [Alt] [P]
+
[P]
Type telephone no.
[F5]
NumbrToSend Specify
Drop Dial base no.
Drop Dial telephone no.
Specify type of no.
[F10]
Type base no.
[F10] [F5]
Enter
[Alt]
+
[F5]