AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 162

Programming Procedures
Display/Instructions
Step
For a single line, do the
5a
following:
1. Specify entry mode.
2. Specify the number of
the trunk with long
disconnect intervals.
3. Save your entry.
5b For a block of lines, do the
following:
1. Select the specific
lines/trunks associated
with the 20 line buttons
on the system
programming console.
2. Assign a long or short
HoId Disconnect
interval.
The green LED next to each
line button indicates the
following:
on = long hold disconnect
interval
off = short hold disconnect
interval
3. Save your entry.
To return to System
6
Programming menu
On the console
Select Entry Mode.
Dial [nnn].
Select Enter.
Select Lines 01-20,
Lines 21–40,
Lines 41–60,
or Lines 62–80.
Toggle the LED On/Off,
as required.
Select Enter.
Select Exit two times.
Hold Disconnect Interval
On the PC
[F6]
Press
Type [nnn]
[F10]
Press
[F1], [F2],
Press
[F3], [F4].
or
Toggle the letter G
On/Off, as required.
[F10]
Press
[F5]
Press two times.
3-71