Table 3-6. Programming Through Integrated Administration - AT&T MERLIN LEGEND Release 2.0 System Programming Manual

Programming Procedures
Set Up
You cannot program the common information until you have completed basic
setup programming for the communications system. Use SPM or the system
programming console to program the following:
Mode of operation
System numbering
System operator positions
Phantom extensions
Trunks to pools assignment
NOTE:
If you do not want all lines to have the same application services, you must
assign lines with the same services to the same pools
Programmable Options
Once you have completed these system programming tasks, you can program
the information in Table 3-6 through Integrated Administration:

Table 3-6. Programming through Integrated Administration

Option
Automated Attendant Calling Group
Call Answer Calling Group
FAX Response Calling Group
Information Service Calling Group
Message Drop Calling Group
Voice Mail Calling Group
Coverage Group
Reliable Disconnect
Delay Ring
Coverage Delay Ring
VMS Transfer Return Interval
Transfer Return Time
The information programmed through Integrated Administration is shared with
the communications system control unit and does not have to be programmed
again when you program the communications system.
Factory Setting
Range
770
7926
7924
7927
7928
7925
1-30
30
yes
1-6 rings
2 rings
1-9 rings
3 rings
0-9 rings
6 rings
0-9 rings
6 rings
Programmable Options
3-585