AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 279

Programming Procedures
Copy Telephone Number to Send
Use this procedure to indicate whether or not the telephone number to send to
the network for calls going out over ISDN lines assigned to a B-channel group,
is copied from the number assigned to that channel.
Select "Do Not Copy Phone Number" when a telephone number to send is
assigned to each channel in the B-channel group or when no telephone number
is to be sent to the network. In the latter case, make sure that no telephone
number is assigned to each channel in the B-channel group by using the
"Telephone Number to Send" procedure.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Copy Telephone Number to Send
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
3-188 Copy Telephone Number to Send
Sys Program
Exit
[F1]
press any key
System manager
All
Not required
Form 3b, Incoming Trunks – DS1 Connectivity
Do not copy
Do not copy, copy
No
No
Lines Trunks PRI
Number Dial group no.
no copy Enter
[F4] [F6] [F2]
[F10]
Specify copy or no copy
[F5] [F5]
[F5]
B ChannlGrp Copy
Enter Specify copy Or
Exit Exit Exit
[F4]
Type group no.
[F10] [F5]