AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 273

Programming Procedures
Display/Instructions
Step
To select a single line, do the
following:
1. Specify entry mode
xx = number entered in Step 11
2. Enter the line number (if
you are programming a
sequence, enter the
lowest number).
3. Save your entry.
To specify a block of lines, do
the following:
1. Specify the lines/trunks
associated with the 20
line buttons on the
system programming
console.
2. Assign Line/Trunk to
group.
The green LED indicates the
following:
on = lines are assigned to
off = ljnes are not assigned
3. Exit the screen.
To return to System
Programming menu
B-ChanneI Groups
3-182
On the console
Select Entry Mode.
Dial [nnn].
Select Enter
Select Lines 01-20,
Lines 21-40, Lines
41-60, or Lines 61-
80.
Toggle the LED On/Off,
as required.
B-channel
to B-channel
Select Exit.
Select Exit three
times.
On the PC
[F6]
Press
Type [nnn].
[F10]
Press
[F1], [F2],
Press
[ F 3 ] , [ F 4 ]
o r
Toggle the letter G
On/Off, as required
[F5]
Press
[F5]
Press three times.