AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 183

Programming Procedures
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Copy Options for Lines/Tunks
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
3-92 Copy Options for Lines/Trunks
Sys Program Exit
[F1] [F5]
press any key
System manager
All (but note differences)
Not required
Form 2c, System Numbering – Trunk Jacks
Form 3c, Incoming Trunks – Tie
Form 3d, Incoming Trunks - DID
Not applicable
Not applicable
N o
Not applicable
To copy individual lines/trunks:
LinesTrunks Copy
trunk no. Enter Dial copy to trunk no.
Exit Exit Exit
To copy blocks of lines/trunks:
LinesTrunks Copy
trunk no. Enter Dial first copy to trunk no. in
block Enter Dial last copy to trunk no. in block
Enter Exit Exit
To copy individual trunks:
[F4] [F7] [F1]
Type copy to trunk no.
[F10]
Type copy from trunk no.
[F5] [F5]
To copy blocks of trunks:
[F4] [F7] [F2]
Dial copy from trunk no.
[F10]
Dial first copy to trunk no. in block
Dial last copy to trunk no. in block
[F5] [F5]
Single Dial Copy from
Enter
Block Dial copy from
E x i t
[F10] [F5]
[F10]
[F10] [F5]