AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 62

Programming with SPM
To access SPM with a local or a remote modem connection, follow these steps:
Step
Start the SPM program by typing spm. If you prefer to program in a
language other than the current language setting for SPM, use the - l
option to the spm command (note that the option is a lowercase letter L, not
the number 1):
The SPM welcome screen appears as shown in Step 2.
3 Make a data connection to the control unit's internal modem. The following
modem commands are for Hayes® and Hayes-compatible modems. They
may not be the commands used by your modem. Refer to your modem
user's guide for specific information.
If the PC
If the PC is in a remote location and your system has activated the
Remote Access feature, type ATDT followed by the remote access
telephone number, followed by W*10, and press
to press it more than once to get the Password prompt.)
If the PC is in a remote location and your system has not activated the
Remote Access feature, place a voice call to the system, using the main
telephone number, and have the operator transfer the call to the modem.
(The operator dials *10 to transfer the call to the modem.) To put the
modem on line, type ATH1 and press
2-12 Starting SPM
Display
spm - l english
spm - l french
spm - l spanish
is
in the same location as the control unit, type *10.
Instructions
Press any key. (You may have to press it
several times). This brings up a blank
screen on which you can enter modem
c o m m a n d s .
[
[ ].
].
(You may need