AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 120

Programming Procedures
Single Renumbering
Use this procedure to assign a specified extension number to a telephone,
accessory, line, pool (Hybrid/PBX only), calling group, paging group, or Listed
Directory Number. Single renumbering is also used for Remote Access, Park,
Idle Line Access (Key and Behind Switch only), and Automatic Route Selection
(Hybrid/PBX only).
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
C A U T I O N :
Select Exit on the console,
extensions. If you press Home, extensions may remain in the forced
idle condition (indicated when the LED next to each DSS button is on).
To restore extensions to their normal operating state, restart the
system.
Programming
Entering
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[ F5 ]
press
Summary: Single Renumbering
Programmable by
Mode
Idle Condition
Planning Forms
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
[ F5 ]
Sys Program
press any key
on the PC before saving your entry or menu selection.
System manager
All
System idle
Form 2a, System Numbering - Station Jacks
Form 2b, System Numbering – Digital Adjuncts
Form 2d, System Numbering – Special Renumbers
Not applicable
Old and new extension numbers
Yes
No
Single
Dial new ext. no.
[ F2 ] [ F2 ]
[ F10 ]
Type new ext. no.
on the PC, after renumbering
Exit
[ F1 ] [ F5 ]
Select item Dial old ext. no.
Enter Exit
Select item Type old ext. no.
[ F10 ]
Single Renumbering
Enter
Exit
[ F5 ] [ F5 ]
3-29