AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 158

Programming Procedures
Display/Instructions
Step
4a For a single line, do the
following:
1. Specify entry mode
2. Specify the number of
the line that requires a
toll prefix (1 or 0 before
the area code.
3. Save your entry.
4b For a block of lines, do the
following:
1. Select the specific lines
or trunks associated
with the 20 line buttons
on the system
programming
console.
2. Specify whether a toll
prefix is needed.
The green LED indicates the
following:
on = toll prefix needed
off = toll prefix not needed
3. Save your entry
To return to System
5
Programming menu
On the console
Select Entry Mode.
Dial [n].
Select Enter.
Select Lines 01-20,
Lines 21-40,
Lines 41–60,
or Lines 61–80.
Toggle the green LED
On/Off, as required.
Select Enter.
Select Exit two times.
On the PC
[F6]
Press
Type [n],
[F10]
Press
[F1], [F2],
Press
[F3], [F4].
or
Toggle the letter G
On/Off, as required.
[F10]
Press
[F5]
Press two times.
Toll Type 3-67