AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 274

Programming Procedures
Network Service
Use this procedure to specify the type of outgoing service provided by each B-
channel group (Megacom WATS and 800, MultiQuest™ Service, ACCUNET™
Switched Digital Service (SDS), or Software Defined Network (SDN).
MultiQuest or any other service not shown on the Network Service screen can
be indicated by entering the 5-digit binary code that represents the service in
the Network Facilities Information Element of ISDN PRI layer 3 signaling
protocol. The code for MultiQuest is 10000.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Network Service
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Sys Program
Exit
[F1]
press any key
System manager
All
Not required
Form 3b, Incoming Trunks - DS1 Connectivity (100D
Module)
Not applicable
AT&T Toll, Local, Mist
No
No
Lines Trunks PRI
NetworkServ Dial group no.
network service Enter
E x i t
[F4] [F6] [F2]
[F10]
Specify network service
[F5] [F5] [F5]
[F5]
B-ChannlGrp
Enter Specify
Exit Exit Exit
[F3]
Type group no.
[F10] [F5]
PRI Facilities 3-183