Table of Contents
Advertisement
Firmware configuration
Interface
type
Preconfigured interfaces
n
n
n
Other default configuration settings
Feature
Central
management
Security policies
Monitoring
Serial port
Change the default password for the admin user
The unique, factory-assigned password for the default admin user account is printed on the bottom
label of the device and on the loose label included in the package.
If you erase the device configuration or reset the device to factory defaults, the password for the
admin user will revert to the original, factory-assigned default password.
To change the default password for the admin user:
Web
IX10 User Guide
Loopback
Default IP
Default Link-local IP
Configuration
Digi Remote Manager enabled as the central management service.
n
Packet filtering allows all outbound traffic.
n
SSH and web administration:
n
Enabled for local administration
l
Firewall zone: Internal
l
Device heath metrics uploaded to Digi Remote Manager at 60 minute
n
interval.
SNMP: Disabled
n
Enabled
n
Serial mode: Remote
n
Label: None
n
Baud rate: 9600
n
Data bits: 8
n
Parity: None
n
Stop bits: 1
n
Flow control: None
n
Change the default password for the admin user
Devices
Default configuration
Ethernet:
n
n
Loopback
n
Ethernet:
n
n
ETH
n
Ethernet:
n
n
ETH
n
Firewall zone:
Loopback
IP address:
127.0.0.1/8
Firewall zone: Setup
IP address
192.168.210.1/24
Firewall zone: Setup
IP address
169.254.100.100/16
41
Advertisement
Table of Contents
