Configuration and management
Interface
type
Preconfigured interfaces
Other default configuration settings
Feature
Central
management
Security policies
Monitoring
Serial port
Change the default password for the admin user
The unique, factory-assigned password for the default admin user account is printed on the bottom
label of the device and on the loose label included in the package. When you first log into the WebUI or
the command line, you will be required to change the password for the admin user prior to being able
to save any configuration changes.
If you erase the device configuration or reset the device to factory defaults, the password for the
admin user will revert to the original, factory-assigned default password.
WebUI
IX10 User Guide
Default IP
n
Default Link-local IP
n
Configuration
Digi Remote Manager enabled as the central management service.
n
Packet filtering allows all outbound traffic.
n
SSH and web administration:
n
Enabled for local administration
l
Firewall zone: Internal
l
Device heath metrics uploaded to Digi Remote Manager at 60 minute
n
interval.
SNMP: Disabled
n
Enabled
n
Serial mode: Remote
n
Label: None
n
Baud rate: 9600
n
Data bits: 8
n
Parity: None
n
Stop bits: 1
n
Flow control: None
n
Change the default password for the admin user
Devices
Default configuration
Ethernet:
n
n
ETH
n
Ethernet:
n
n
ETH
n
Firewall zone:
Setup
IP address
192.168.210.1/24
Firewall zone:
Setup
IP address
169.254.100.100/16
33