Change The Default Lan Subnet - Digi IX30 User Manual

Interfaces
d. Set the device to the new bridge:
(config network interface LAN_bridge_interface)> device
/network/bridge/LAN_bridge
(config network interface LAN_bridge_interface)>
e. Set the IPv4 address and netmask for the interface, using the format IPv4_
address/netmask, for example, 192.168.3.1/24:
(config network interface LAN_bridge_interface)> ipv4 address
192.168.3.1/24
(config network interface LAN_bridge_interface)>
f. Enable the DHCP server:
(config network interface LAN_bridge_interface)> ipv4 dhcp_server
enable true
(config network interface LAN_bridge_interface)>
5. Disable the eth1 interface:
(config)> network interface eth1 enable false
(config)>
6. Save the configuration and apply the change:
(config network interface LAN_bridge_interface)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Change the default LAN subnet

You can change the IX30 default LAN subnet—192.168.2.1/24—to any range of private IPs. The local
DHCP server range will also change to the range of the LAN subnet.
To change the LAN subnet:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
IX30 User Guide
Use Digi Remote Manager to view and manage your
Local Area Networks (LANs)
166