Configure An Open Wi-Fi Access Point - Digi TX54 User Manual

Wi-Fi

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set transmit power for the radio:
a. Determine available radios:
(config)> network wifi radio ?
Additional Configuration
----------------------------------------------------------------------
---------
wifi1
wifi2
(config)> network wifi radio
b. Set the transmit power percentage for the appropriate radio:
(config)> network wifi radio wifi1 tx_power value
(config)>
where value is any integer between 1 and 100 and represents the percentage of transmit
power that the Wi-Fi module should use.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure an open Wi-Fi access point

This procedure configures a Wi-Fi access point that does not require a password for client
connections.
By default, the TX54 device comes with either one or two preconfigured access points:
Single-Wi-Fi models: Digi AP (Wi-Fi).
n
Dual-Wi-Fi models: Digi AP (Wi-Fi) and Digi AP (Wi-Fi2).
n
You cannot delete default access points, but you can modify them or you can create your own access
points.
TX54 User Guide
Configure an open Wi-Fi access point
Wi-Fi1 radio
Wi-Fi2 radio
242