Table of Contents
Advertisement
Wi-Fi
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure an open Wi-Fi access point
This procedure configures a Wi-Fi access point that does not require a password for client
connections.
By default, the IX20W device comes with one preconfigured access point, Digi AP. You cannot delete
default access points, but you can modify them or you can create your own access points.
Note
The IX20W device supports a maximum of two enabled access points, regardless of the number
of enabled Wi-Fi clients.
Required configuration items
Enable the Wi-Fi access point
n
The Service Set Identifier (SSID) for the access point.
n
Configure open security for the access point.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
n
access point to a LAN interface or to a bridge. See
more information.
Additional configuration items
Determine whether to broadcast the access point's SSID.
n
Determine whether to isolate clients connected to this access point, so that they cannot
n
communicate with each other.
The amount of time to wait before changing the group key.
n
To configure a Wi-Fi access point with no security:
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX20 User Guide
Configure an open Wi-Fi access point
Configure a LAN
and
Configure a bridge
for
194
Advertisement
Table of Contents
