Configure An Open Wi-Fi Access Point - Digi LR54 User Manual

Wi-Fi
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure an open Wi-Fi access point

This procedure configures a Wi-Fi access point that does not require a password for client
connections.
By default, the LR54W device comes with two preconfigured access points, Digi AP (Wi-Fi1) and Digi
AP (Wi-Fi2). You cannot delete default access points, but you can modify them or you can create your
own access points.
Required configuration items
Enable the Wi-Fi access point
n
Select a Wi-Fi radio for the access point.
n
The Service Set Identifier (SSID) for the access point.
n
Configure open security for the access point.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
n
access point to a LAN interface or to a bridge. See
Configure a bridge
Additional configuration items
Determine whether to broadcast the access point's SSID.
n
Determine whether to isolate clients connected to this access point, so that they cannot
n
communicate with each other.
The amount of time to wait before changing the group key.
n
To configure a Wi-Fi access point with no security:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
LR54 User Guide
for more information.
Use Digi Remote Manager to view and manage your
Configure an open Wi-Fi access point
Configure a Local Area Network (LAN) and
270