Table of Contents
Advertisement
Digi IX10 hardware reference
Item
Decription
1. LEDs
See
2. Antenna
Main (WWAN1) and auxillary (WWAN2) cellular antenna connectors.
connectors
The ERASE button is used to perform a device reset, and it has three modes:
3.
ERASE
button
4. Ethernet
LAN-enabled by default.
port
5. Serial
See
port
6. Power
IX10 power supply
suppy
Item
Decription
7. SELECT
The SELECT button is used to manually toggle between the two SIM slots.
8. SIM slots See
IX10 LEDs
The IX10 LEDs are located on the top front panel. . During bootup, the front-panel LEDs light up in
sequence to indicate boot progress.
IX10 User Guide
IX10 LEDs
.
1. Configuration reset: Pressing the ERASE button one time will reset the
device configurations to the factory default. It will not remove any
automatically generated certificates and keys.
2. Full device reset: After the device reboots from the first button press, press
the ERASE button again before the device is connected to the internet to also
remove generated certificates/keys.
3. Firmware reversion: Press and hold the ERASE button and then power on
the device to boot to the version of firmware that was used prior to the
current version.
Digi IX10 serial connector pinout
requirements.
Install SIM cards
for more details.
for information about the serial port pin-out.
IX10 LEDs
27
Advertisement
Table of Contents
