Ix14 Power Supply Requirements; Ix14 Leds - Digi IX14 User Manual

Digi IX14 hardware reference
Port/connector
WAN/ETH1
SERIAL1
Power
WWAN1-1
WWAN1-2

IX14 power supply requirements

IX14 is intended to be powered by a certified power supply with output rated at either 12 VDC/0.75 A
or 24 VDC/0.375 A minimum.
If the IX14 is operated in an ambient temperature range from +0 C to +40 C, use the Digi power
n
supply accessory kits 76002078 or 76002080 to meet the temperature criteria.
If the IX14 is operated in an ambient temperature range from -34 C to +74 C, use the Digi power
n
supply accessory kits 76002079 or 76002081 to meet the temperature criteria.
If you are providing the DC power source with a non-Digi power supply, you must use a
n
certified LPS power supply rated at either 12 VDC/0.75 A or 24 VDC/0.375 A minimum. The
voltage tolerance supports +/- 10% (9 VDC to 30 VDC) at 9 Watts minimum.

IX14 LEDs

Power
WWAN signal
IX14 User Guide
Description
See Connect the WAN/ETH1
See Connect the serial port
See Power on the IX14.
See Attach and position
Solid blue
Initial power on as router prepares to boot up
Flashing blue
Router is booting up
Solid blue
Router bootup is complete when flashing stops
Off
SIMs are not in use
Solid red
Very Poor signal (-113 dBm to -99 dBm)
Solid orange
Poor signal (-98 dBm to -87 dBm)
Solid yellow
Fair signal (-86 dBm to -76 dBm)
IX14 power supply requirements
port.
and Serial port.
antennas.
26