Access Rules - Safran VersaSync User Manual

2.8.5

Access Rules

Network access rules restrict access to only those assigned networks or nodes
defined. If no access rules are defined, access will be granted to all networks and
nodes.
To
CHAPTER •
2 VersaSync User Manual Rev. 12
Note:
ports; a route that has been used elsewhere will be rejec-
ted.
Note:
If a port is not given its own static route, all packets from
that port will be sent through the default.
Note: In order to configure Access Rules, you need
ADMINISTRATOR rights.
configure a new, or
1. Navigate to the MANAGEMENT > Network Setup
2. In the Actions panel on the left, click on
3. The Network Access Rules
4. In the Allow From
to add direct IP addresses, but instead they must be input as blocks, i.e. you
need to add /32 at the end of an IP address to ensure that only that
address is allowed.
Example: 10.2.100.29/32 will allow only 10.2.100.29 access.
I P a d d r e s s n o m e n c l a t u r e :
IPv4—
10.10.0.0/16
net mask in prefix form. See the table
for a list of subnet mask values.
Do not use the same route for different Ethernet
The eth0 port is the default port for static routing.
delete an existing access rule:
window displays:
field, enter a valid IP address. It is not possible, however,
, where
10.10.0.0
"Subnet Mask Values" on page 390
2.8 Configuring Network Settings
screen.
Access Control.
is the IP address and is the sub-
16
77