Table of Contents
Advertisement
2.7 Connecting the GNSS Input
a. Configure SecureSync via the unit's front panel.
b. Configure SecureSync by means of a PC connected to an existing network.
c. Configure SecureSync by connecting a stand-alone computer directly via a ded-
On Eth0:
port is illuminated. The
traffic is present.
2.7
Connecting the GNSS Input
Typical installations include GNSS as an external reference input.
1.
2. Connect the GNSS cable to the rear panel antenna input jack.
2.8
Powering Up the Unit
1. After installing your SecureSync unit, and connecting all references and network(s),
24
When connecting to a hub, router, or network computer, use a
through wired, shielded CAT 5, Cat 5E or CAT 6 cable with RJ45 con-
nectors (Eth0) or SFP connectors
ernet port on the SecureSync rear panel, and the opposite end of the cable to
a network hub or switch.
icated network cable (standard-wired, or crossover cable):
When connecting directly to a stand-alone PC, use a network cable. Connect
the cable to the NIC card of the computer.
Since no DHCP server is available in this configuration both SecureSync, and
the PC must be configured with static IP addresses that are on the same sub-
net (10.1.100.1 and 10.1.100.2 with a subnet mask value of 255.255.255.0 on
both devices, for example).
Once the unit is up and running, verify that the
amber
Install a GNSS antenna, surge suppressor, antenna cabling, and GNSS preamplifier
(if required). Refer to the documentation included with your GNSS antenna for
information regarding GNSS antenna installation.
Note:
The SMA-to-N-type conversion cable included in the ancillary kit
is approved for pull weight of up to 60 lbs. If you are using a heavier
cable, you will need to apply appropriate strain relief.
verify that power is connected, and wait for the device to boot up.
(Eth1). Connect one end to the Eth-
"Activity" link light may periodically illuminate when network
straight-
green
link light on the Ethernet
SecureSync 2400 Getting Started Guide Rev. 4
Advertisement
Table of Contents
