Secondary Accounting (Hwtacacs Scheme View) - HP 5120 SI series Command Reference Manual

Description
Use the retry stop-accounting command to set the maximum number of stop-accounting request
transmission attempts.
Use the undo retry stop-accounting command to restore the default.
By default, the maximum number of stop-accounting request transmission attempts is 100.
Related commands:
stop-accounting-buffer.
Examples
# Set the maximum number of stop-accounting request transmission attempts to 50.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] retry stop-accounting 50

secondary accounting (HWTACACS scheme view)

Syntax
secondary accounting ip-address [ port-number | key [ cipher | simple ] key ] *
undo secondary accounting [ ip-address ]
View
HWTACACS scheme view
Default level
2: System level
Parameters
ip-address: IP address of the secondary HWTACACS accounting server, a valid unicast address in
dotted decimal notation. The default is 0.0.0.0.
port-number: Port number of the secondary HWTACACS accounting server. It ranges from 1 to 65535
and defaults to 49.
key [ cipher | simple ] key: Sets the shared key for secure communication with the secondary
HWTACACS accounting server. Make sure the shared key configured on the device is the same as the
one configured on the server.
• cipher key: Sets a ciphertext shared key. The key argument is case sensitive. If you specify neither this keyword
nor the simple keyword, the shared key is set in plain text.
In non-FIPS mode, the key is a string of 1 to 373 characters.
In FIPS mode, the key is a string of 8 to 373 characters.
simple key: Sets a plaintext shared key. The key argument is case sensitive. If you specify neither this keyword
•
nor the cipher keyword, the shared key is set in plain text.
In non-FIPS mode, the key is a string of 1 to 255 characters.
In FIPS mode, the key is a string of 8 to 255 characters and must contain digits, uppercase
letters, lowercase letters, and special characters.
Description
Use the secondary accounting command to specify a secondary HWTACACS accounting server.
reset stop-accounting-buffer,
83
hwtacacs scheme, and display