Igmp-Snooping Special-Query Source-Ip; Igmp-Snooping Static-Group - HP 3600 v2 Series Command Reference Manual

igmp-snooping special-query source-ip

Syntax
igmp-snooping special-query source-ip { ip-address | current-interface }
undo igmp-snooping special-query source-ip
View
VLAN view
Default level
2: System level
Parameters
ip-address: Specifies a source address for IGMP group-specific queries.
current-interface: Specifies the address of the current VLAN interface as the source address of IGMP
group-specific queries. If the current VLAN interface does not have an IP address, the default IP address
0.0.0.0 is used as the source IP address of IGMP group-specific queries.
Description
Use igmp-snooping special-query source-ip to configure the source IP address for IGMP group-specific
queries.
Use undo igmp-snooping special-query source-ip to restore the default.
By default, the source IP address of IGMP group-specific queries is 0.0.0.0.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable.
Examples
# In VLAN 2, enable IGMP snooping and specify 10.1.1.1 as the source IP address of IGMP
group-specific queries.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping special-query source-ip 10.1.1.1

igmp-snooping static-group

Syntax
igmp-snooping static-group group-address [ source-ip source-address ] vlan vlan-id
undo igmp-snooping static-group group-address [ source-ip source-address ] vlan vlan-id
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default level
2: System level
29