Display Igmp Host Group - HP 6127XLG Series Command Reference Manual

1.1.1.2
1.1.1.3
1.1.1.4
# Display the number of ARP flood suppression entries on the master device.
<Sysname> display arp suppression vsi count
Total entries: 3
Table 1 Command output
Field
Link ID
Aging
Related commands
arp suppression enable
•
reset arp suppression vsi
•

display igmp host group

Use display igmp host group to display information about the multicast groups that contain IGMP
host-enabled interfaces.
Syntax
display igmp host group [ group-address | interface interface-type interface-number ] [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
group-address: Specifies a multicast group address. The value range is 224.0.1.0 to 239.255.255.255.
If you do not specify a multicast group, the command displays information about all multicast groups.
interface interface-type interface-number: Specifies an interface by its type and number. If you do not
specify an interface, the command displays multicast group information for all interfaces.
verbose: Displays detailed multicast group information. If you do not specify this keyword, the command
displays brief multicast group information.
Usage guidelines
For the VXLAN multicast source interface of a multicast-mode VXLAN to join its VXLAN multicast group,
you must enable the IGMP host function.
Use this command to verify the following information:
Multicast group information for VXLANs.
•
Group membership status of VXLAN multicast source interfaces.
•
000f-e201-0101 vsi1
000f-e201-0202 vsi1
000f-e201-0203 vsi2
Description
Link ID that uniquely identifies an AC or a VXLAN tunnel on a VSI.
Remaining lifetime (in minutes) of the ARP flood suppression entry. When the
timer expires, the entry is deleted.
3
0x5000003 14
0x5000004 18
0x5000005 10