4) Inspection of parts and report of findings
See
General note
Measure all parts listed in the dimension sheets. These are attached directly after
each section.
All measurements must be entered in the corresponding dimension sheets as
shown.
Following the description how to fill in the dimension sheets.
Filling in the di-
mension sheets
If the engine is overhauled/repaired before the end of the TBO, the 50 %
specified values (3) for wear limits do not apply and must be calculated
separately in accordance with section 5„Classification of parts for main-
tenance/repair".
- Look up the desired control point code (1) in the illustration in the specified
section.
- The maximum limits for wear are divided into the columns maximum wear
100 % (2) and 50 % wear (3).
- The first line (4) gives the maximum permissible value in [mm], the second line
(5) in [inches].
- The respective actual value must be entered in the corresponding box (6) in
[mm] or [inches].
- The actual value for any part which has been replaced must be entered in the
corresponding field (7) in [mm] or [inches].
Where measurement values are taken in hundredths of a millimeter or more
precisely, the temperature of the part must be 20 to 25 °C (68 to 77 °F).
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Fig. 2.
WARNUNG
WARNUNG
NOTICE
NOTICE
00-00-00
Page 17
July 01/2012