Table 5-8 Parameter Attributes - Quick Commissioning; Table 5-9 Parameter Attributes - Value Range; Table 5-10 Data Sets - Siemens SINAMICS G120 Operating Instructions Manual

Note
Parameter values that are changed using STARTER or a higher-level control do not have to
be acknowledged.
Quick commissioning
This parameter attribute identifies as to whether the parameter is included in the quick
commissioning (QC) (P0010 = 1).
Table 5-8
QC
No
Yes
Value range
The value range, which is specified as a result of the data type, is restricted by the minimum
and maximum values (min, max) and using the inverter/motor quantities. Straightforward
commissioning is guaranteed in so much that the parameters have a default value. These
values (min, max, def) are so permanently saved in the inverter and cannot be changed by
the user.
Table 5-9
Value range
-
Min
Max
Def
Data sets
A detailed description for the data sets is given in the respective section
Table 5-10
BICO
CDS
DDS
Control Units CU240S
Operating Instructions, 11/2006, A5E00766042B AA
Parameter attributes - Quick commissioning
Description
The parameter is not included in the quick commissioning
The parameter is included in the quick commissioning
Parameter attributes - Value range
Description
No value entered (e.g.: "r parameter")
Minimum value
Maximum value
Default value
Data sets
Description
Command data set
Drive data set
Commissioning (software)
5.2 Parameters
5-9