Table of Contents
Advertisement
4.5
Settings
The settings form is reached from the main menu.
The button "Calibrate analogue input" displays a form where the analogue input for Smart can be calibrated.
The button "Edit analogue conversion" shows a form where the analogue input can be converted to show any units
and values when displayed in the graph.
The button "OK" closes the form.
4.6
Edit the analogue conversion
To change how the analogue values are displayed in the graph you can either click on the button "Edit analogue
conversion" in the settings form (see chapter 4.5) or click on "Options" – "Edit analogue conversion" in the graph
form (see chapter 4.9). A small form is shown where the conversion of the analogue values can be edited.
2TLC172188M0201, rev. H
2012-01-03
Select language
"Language" selects the language for messages and texts in
Smart Manager.
Standard
"Standard" selects the standards used for the safety distance
calculations.
Communication port
"Connection" states which communications port the computer
uses to communicate with Smart Logger. If you have problems
getting connection to Smart Logger, you can see which
comport you should use in Windows Device Manager. Smart
Logger is displayed under Ports as 'USB Serial Port'.
In the upper textboxes the values corresponding to 20 mA are
entered.
In the middle textboxes the values corresponding to 4 mA are
entered.
In the bottom textboxes the units of the analogue values are
entered.
The button "OK" saves the changes and closes the form.
The button "Cancel" closes the form without saving the changes.
28
www.abb.com/lowvoltage
Advertisement
Table of Contents
