Connecting To Ic693Cmm311; Connecting To Ic697Cmm711; Station Number Setting - Mitsubishi Electric GT14 User Manual

55.5.3 Connecting to IC693CMM311


Communication settings
Make the communication settings using the
engineering tool.
When making the settings, set [Configuration Mode] on
the [Setting] tab of the engineering tool to "SNP only".
Setting item
*1
SNP Enable
*2
SNP Mode
*3
Interface
Data Rate
Parity
Stop Bits
*4
Flow Control
*5
Turn Around Delay
*6
Timeout
*1 Set to YES.
*2 Set to Slave.
*3 Set the communication format to be used.
(only when connecting to Port2)
*4 Set to NONE.
*5 Set to NONE.
*6 Set to LONG.

55.5.4 Connecting to IC697CMM711


Communication settings
Make the communication settings using the
engineering tool.
When making the settings, set [Configuration Mode] on
the [Setting] tab of the engineering tool to "SNP only".
Setting item
*1
SNP Enable
*2
SNP Mode
*3
Interface
Data Rate
Parity
Stop Bits
*4
Flow Control
*5
Turn Around Delay
*6
Timeout
*1 Set to YES.
*2 Set to Slave.
*3 Set the communication format to be used.
(only when connecting to Port2)
*4 Set to NONE.
*5 Set to NONE.
*6 Set to LONG.
55 - 26
55. CONNECTION TO GE PLC
55.5 PLC Side Setting
PLC side setting
YES
Slave
RS232, RS485
9600bps, 19200bps
ODD, NONE, EVEN
1bit, 2bits
NONE
NONE
Long
PLC side setting
YES
Slave
RS232, RS485
9600bps, 19200bps
ODD, NONE, EVEN
1bit, 2bits
NONE
NONE
Long

55.5.5 Station number setting

Set each station number so that no station number
overlaps.
The station number can be set without regard to the cable
connection order. There is no problem even if station
numbers are not consecutive.
Station
No.3
GOT
Examples of station number setting
(1) Direct specification
Specify the station No. of the PLC to be changed when
setting device.
Specification range
00 to 31
POINT POINT POINT
PLC Station NO. settings
Make sure to set a 2-digit number for the station No. of
the PLC to be monitored by the GOT.
Station Station Station
No.0 No.15 No.6