Ntp Peer - Allied Telesis x310-26FT Command Reference Manual

NTP C
OMMANDS

NTP PEER

ntp peer
Overview Use this command to configure an NTP peer association. An NTP association is a
peer association if this system is willing to either synchronize to the other system,
or allow the other system to synchronize to it.
Use the no variant of this command to remove the configured NTP peer
association.
ntp peer {<peeraddress>|<peername>}
Syntax
ntp peer {<peeraddress>|<peername>} [prefer] [key <key>]
[version <version>]
no ntp peer {<peeraddress>|<peername>}
Mode Global Configuration
Examples See the following commands for options to configure NTP peer association, key
and NTP version for the peer with an IPv4 address of 192.0.2.23:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config)#
To remove an NTP peer association for this peer with an IPv4 address of
192.0.2.23, use the following commands:
awplus#
awplus(config)#
C613-50103-01 REV A
Parameter
<peeraddress>
<peername>
prefer
key <key>
version <version> <1-4>
configure terminal
ntp peer 192.0.2.23
ntp peer 192.0.2.23 prefer
ntp peer 192.0.2.23 prefer version 4
ntp peer 192.0.2.23 prefer version 4 key 1234
ntp peer 192.0.2.23 version 4 key 1234
ntp peer 192.0.2.23 version 4
ntp peer 192.0.2.23 key 1234
configure terminal
no ntp peer 192.0.2.23
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specify the IP address of the peer, entered in the form
A.B.C.D for an IPv4 address, or in the form X:X::X:X for an IPv6
address.
Specify the peer hostname. The peer hostname can resolve
to an IPv4 and an IPv6 address.
Prefer this peer when possible.
<1-4294967295>
Configure the peer authentication key.
Configure for this NTP version.
2254